Sika Multiseal Sealing Flashing Tape 150mm X 10m SKMULTI150

Sika Multiseal Sealing Flashing Tape 150mm x 10 meter

Size 150mm x 10m

Sika 446883

MPN SKMULTI150

Barcode 5055492700292

Sika Multiseal Sealing Flashing Tape 150mm Wide and grey in colour a self adhesive flashing tape that has a strong self-adhesive bituminous sealing tape ,used for the sealing of cracks and joints

in many common domestic and commercial situations.

Made from aluminium foil reinforced by a polyester film and coated with a cold-adhesive bituminous compound

simply press the tape into place by hand or roller.

Multiseal Flashing Tape Benefits

• Replaces need for expensive lead flashing.
• Self-adhesive requires no separate glue.
• Very easy to apply
• Very economical
• Good adhesion to many substrates
• Weather-proof
• UV-resistant
• Can be over-painted
• Can be applied at low temperatures

Areas of Use

• General repair to existing flashing.
• Flashing bituminous felt and similar types of roofs.
• Flashing parapet walls.
• Sealing roof glazing.
• Replacing lost lead flashing.
• Repairs to cracks in concrete.
• Repairs to lead gutters.
• Sealing capping bolts in roof sheets.
• Sealing roof ridges.
• Flashing between timber brickwork or blockwork cavities.
• Flashing of skylights

Video Demonstration of the Sika Multiseal Sealing Tape.

Notes:

Do not apply to damp surfaces.

In cold weather adhesion may be reduced.

Bring up to temperature or heat bitumen adhesive layer gently with a hot air gun

to improve adhesion & pliability.

Surface Preparation:

Surfaces must be dry,

Sound free from oil, grease and dust

Remove all loose material by scraper or wire brush.

Porous surfaces, such as concrete or brick, should be primed using

Everbuild flashing tape primer.

Applying:

1. Cut to the required length.

2. Peel beck approximately 5cm of release carrier and place the tape into position.

3. Continue removing the release carrier whilst firmly placing the tape

4. Avoid unnecessary creasing.

5. Ensure intimate contact and ensure no air is trapped.

6. Using a small roller ensure that all edges and overlaps are sealed properly.

7. Overlaps should be at least 25mm.

SKMULTI150 Official Information:

Manufacturer Sika Flashing Tape Product Page